Removing The Defective Sas Raid Controller; Installing The New Sas Raid Controller; Connecting Cables To The Expansion Card; Connecting A Backup Unit To The Expansion Card - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

9.3.3.3

Removing the defective SAS RAID controller

"Removing the SAS RAID controller" on page 207
Ê
Ê If the RAID card holder on the defective controller is to be reused, remove it
from the board as described in section
on page 204.
9.3.3.4

Installing the new SAS RAID controller

Ê If applicable, install the RAID card holder on the new SAS RAID controller
as described in section
"Installing the SAS RAID controller" on page 203
Ê
9.3.3.5

Connecting cables to the expansion card

Ê Connect SAS cables to the SAS RAID controller.
I
For a complete cabling overview, please refer to section
overview" on page
9.3.3.6

Connecting a backup unit to the expansion card

Ê If applicable, connect a BBU to the expansion card as described in sections
"Installing a BBU" on page 227
9.3.3.7

Concluding steps

Perform the following procedures:
"Installing the air duct" on page 74
Ê
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
"Connecting the server to the power source" on page 81
Ê
"Closing the rack door" on page 84
Ê
RX300 S7
"Preparing the SAS RAID controller" on page
525.
or "Installing an FBU" on page
Upgrade and Maintenance Manual
Expansion cards and backup units
"Preparing the SAS RAID controller"
77.
204.
"Cables
241.
211