System board and components
Ê Remove the nylon screw on the defective UFM board (1).
Ê Disconnect and remove the defective UFM board (2).
Figure 290: Removing the UFM board (B)
Ê The UFM spacer remains on the system board.
14.2.2.4 Concluding steps
Perform the following procedures:
"Installing the air duct" on page 74
Ê
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
"Connecting the server to the power source" on page 81
Ê
"Closing the rack door" on page 84
Ê
462
Upgrade and Maintenance Manual
77.
RX300 S7