Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual page 83

Follow the safety instructions in chapter
●
page 43.
Ê Connect all peripheral cables to the rear connector panel of the server.
Ê Connect and secure the power cords as described in section
the server to the power source" on page
Ê Connect all power cords to the power outlets.
I
To provide true phase redundancy, the second power supply should
be connected to a different AC power source from the other supply. If
one AC power source should fail, the server will still continue to run.
Figure 24: Power button on the front panel
Ê Press the On / Off button to start up the server (1).
Ê Ensure that the power-on indicator above the On / Off button is lit green.
I
For more information, refer to section
indicators" on page
RX300 S7
555.
Upgrade and Maintenance Manual
Basic hardware procedures
"Important information" on
81.
"Front panel controls and
"Connecting
83