Installing A 3.5-Inch Hdd Module - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

I
Dummy modules have been installed into unused HDD bays. Before
installing an additional HDD, the dummy module needs to be removed
from the desired drive bay.
Ê Press in on the locking tabs on both sides of the dummy module to
disengage the locking mechanism (1).
Ê While keeping the locking tabs pressed, pull the dummy module out of its
bay (2).
V
CAUTION!
Save the dummy module for future use.
Always replace dummy modules into unused HDD bays to comply
with applicable EMC regulations and satisfy cooling requirements.
7.2.2.4

Installing a 3.5-inch HDD module

Figure 44: Opening the 3.5-inch HDD module locking lever
Ê While pressing down on the locking button (1) fold up the lever (2).
RX300 S7
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
141