Hard disk drives / solid state drives
7.2.3.4
Installing a 3.5-inch HDD dummy module
V
CAUTION!
If the removed HDD module is not replaced immediately, always replace
a dummy module into the unused HDD / SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 47: Installing a 3.5-inch HDD dummy module
Ê Slide the HDD dummy module into the drive bay until it locks in place.
7.2.3.5
Concluding steps
Perform the following procedures:
"Closing the rack door" on page 84
Ê
144
Upgrade and Maintenance Manual
RX300 S7