Installing A New Bbu; Concluding Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Figure 107: Disconnecting the BBU cable from the BBU
Ê Carefully disconnect the BBU cable from the BBU.
9.5.3.5

Installing a new BBU

Ê Install the new BBU into the BBU holder as described in section
the BBU" on page
"Installing the BBU holder onto the air duct" on page 230
Ê
Ê Connect the BBU to the controller.
9.5.3.6

Concluding steps

Perform the following procedures:
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
"Connecting the server to the power source" on page 81
Ê
Ê If applicable, update the firmware of the RAID controller that has been
connected to the BBU as described in section
firmware" on page
"Enabling SVOM boot watchdog functionality" on page 101
Ê
RX300 S7
229.
96.
Upgrade and Maintenance Manual
Expansion cards and backup units
77.
"Updating RAID controller
"Preparing
239