Concluding Steps; Replacing A 2.5-Inch Hdd / Ssd Module - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Figure 59: Installing a 2.5-inch HDD / SSD dummy module
Ê Slide the HDD / SSD dummy module into the drive bay until it locks in place.
7.3.3.5

Concluding steps

Perform the following procedures:
"Closing the rack door" on page 84
Ê
7.3.4

Replacing a 2.5-inch HDD / SSD module

Customer Replaceable Units (CRU)
Average task duration: 5 minutes
V
CAUTION!
Only remove an HDD / SSD module during operation if the drive is
●
not currently being accessed. Observe the indicators for the
corresponding HDD / SSD modules, see "PRIMERGY RX300 S7
Server - Operating manual".
RX300 S7
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
157