Removing A 2.5-Inch Hdd / Ssd Module - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

"Opening the rack door" on page 64
Ê
7.3.3.3

Removing a 2.5-inch HDD / SSD module

Figure 57: Disconnecting a 2.5-inch HDD / SSD module
Ê Pinch the green locking clips (1) and fully open the locking lever (2).
I
Thereby, the HDD / SSD module is pushed out of its drive bay by
about 1 cm and disconnected from the SAS / SATA backplane.
Ê Wait about 30 seconds to allow the hard disk drive to spin down.
I
This is not necessary when removing a solid state drive.
RX300 S7
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
155