Hard disk drives / solid state drives
Figure 45: Inserting the 3.5-inch HDD module
Ê Insert the HDD module into a drive bay and carefully push back as far as it
will go (1).
Ê Fold down the lever to lock the HDD module in place (2).
7.2.2.5
Concluding steps
Perform the following procedures:
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
"Closing the rack door" on page 84
Ê
7.2.3
Removing 3.5-inch HDD modules
Customer Replaceable Units (CRU)
Average task duration: 5 minutes
7.2.3.1
Required tools
Preliminary and concluding steps: tool-less
●
Removing a 3.5-inch HDD module: tool-less
●
142
108.
Upgrade and Maintenance Manual
"Performing a RAID
RX300 S7