Replacing The Ufm Board; Required Tools; Preliminary Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

"Enabling BitLocker functionality" on page 107
Ê

14.2.3 Replacing the UFM board

Field Replaceable Units (FRU)
Average hardware task duration: 10 minutes
Average software task duration: 5 minutes

14.2.3.1 Required tools

Preliminary and concluding steps:
●
– combination pliers and flat nose pliers
Replacing the UFM:
●
– Phillips PH0 / (+) No. 0 screw driver

14.2.3.2 Preliminary steps

Perform the following procedures:
"Disabling BitLocker functionality" on page 85
Ê
"Disabling SVOM boot watchdog functionality" on page 86
Ê
"Opening the rack door" on page 64
Ê
"Locating the defective server" on page 56
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting power cords" on page 66
Ê
"Extending the server out of the rack" on page 69
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
"Removing the server cover" on page 72
Ê
"Removing the air duct" on page 73
Ê
RX300 S7
Upgrade and Maintenance Manual
System board and components
70.
463