Removing Onboard Sas Enabling Key; Concluding Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70
"Removing the server cover" on page 72
Ê
"Removing the air duct" on page
Ê

14.4.2.3 Removing onboard SAS enabling key

Figure 306: Removing onboard SAS enabling key
Ê Firmly pull up on the release lash until the onboard SAS enabling key pops
out of its connector.

14.4.2.4 Concluding steps

Perform the following procedures:
"Installing the air duct" on page 74
Ê
"Mounting the server cover" on page 76
Ê
RX300 S7
73.
Upgrade and Maintenance Manual
System board and components
485