System board and components
14.1.4 Installing the CMOS battery
Figure 285: Installing the CMOS battery
Ê At a slight angle, fit the new CMOS battery into its socket as shown (1).
V
CAUTION!
Ensure to insert the CMOS battery with the positive pole (label side)
facing up as shown (see close-up).
Ê Fold down the CMOS battery (2) until it locks in place.
Ê Ensure that the locking spring (3) is properly engaged.
14.1.5 Concluding steps
Perform the following procedures:
Ê Dispose of the CMOS battery in accordance with local regulations
concerning special waste.
"Installing the air duct" on page 74
Ê
454
Upgrade and Maintenance Manual
RX300 S7