Installing The Air Duct With A Bbu - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê Insert the BBU holder into the air duct so that the three fixation bolts on the
air duct rest in the wide ends of the keyhole slots on the holder (see close-
up) (1).
Ê Slide the BBU holder to the right as far as it will go (2).
The fixation bolts on the air duct will lock in the narrow ends of the keyhole
slots on the BBU holder.
Ê Ensure that the locking handle on the BBU holder properly snaps in place
(3).
9.5.1.5

Installing the air duct with a BBU

Figure 103: Connecting the BBU to the controller
Ê Insert the air duct.
Ê Tilt up the air duct a little.
Ê Thread the BBU cable though the gap in the air duct (1)
Ê Connect the BBU cable to the RAID controller (2).
I
The connector side with the three dots points towards you.
232 Upgrade and Maintenance Manual
RX300 S7