Disconnecting Power Cords - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Basic hardware procedures
Ê Shut down the server (1).
I
If the system is running an ACPI-compliant operating system,
pressing the On / Off button will perform a graceful shutdown.
Ê Switch on the ID indicator on the front and rear connector panels of the
server as described in section
4.4

Disconnecting power cords

Removing the server from the mains
I
If there are installed two power supplies remove both power cords.
Figure 9: Removing the power cord from the PSU cable clamp
Ê Open on the locking lever on the PSU cable clamp (1).
Ê Disconnect the power cord from the PSU and remove it from the cable tie
(2).
66
"Locating the defective server" on page
Upgrade and Maintenance Manual
56.
RX300 S7