Expansion cards and backup units
9.2.2
Removing expansion cards
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
9.2.2.1
Required tools
Preliminary and concluding steps: tool-less
●
Removing expansion cards:
●
– Phillips PH2 / (+) No. 2 screw driver
9.2.2.2
Preliminary steps
Perform the following procedures:
"Opening the rack door" on page 64
Ê
"Locating the defective server" on page 56
Ê
"Disabling BitLocker functionality" on page 85
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting power cords" on page 66
Ê
Ê Remove all external cables from the expansion card to be removed.
"Extending the server out of the rack" on page 69
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
"Removing the server cover" on page 72
Ê
"Removing the air duct" on page 73
Ê
196
Upgrade and Maintenance Manual
70.
RX300 S7