Connecting Cables To The Expansion Card; Connecting A Battery Backup Unit To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Ê If applicable, reinstall SFP+ transceiver modules on the new expansion
card, as described in section
page 262.
9.2.3.5

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
overview" on page
9.2.3.6

Connecting a battery backup unit to the expansion card

Ê If applicable, connect a BBU to the expansion card as described in section
"Installing a BBU" on page
9.2.3.7

Concluding steps

Perform the following procedures:
"Installing the air duct" on page 74
Ê
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the power source" on page 81
Ê
"Enabling replaced components in the system BIOS" on page 101
Ê
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 108.
Ê After replacing a network controller in a server running Linux OS, update its
MAC address in the related NIC definition file as described in section
"Updating the NIC configuration file in a Linux environment" on page 105
"Updating RAID controller firmware" on page 96
Ê
"Enabling SVOM boot watchdog functionality" on page 101
Ê
RX300 S7
"Installing SFP+ transceiver modules" on
525.
227.
"Looking up changed MAC / WWN addresses"
Upgrade and Maintenance Manual
Expansion cards and backup units
77.
"Cables
201