Ftp Session Example Of Firmware File Upload; Tftp File Upload - ZyXEL Communications P-2612HW-F1 User Manual

Use "put" to transfer files from the computer to the device, for example, "put
6
firmware.bin ras" transfers the firmware on your computer (firmware.bin) to the
device and renames it "ras". Similarly, "put config.rom rom-0" transfers the
configuration file on your computer (config.rom) to the device and renames it
"rom-0". Likewise "get rom-0 config.rom" transfers the configuration file on the
device to your computer and renames it "config.rom." See earlier in this chapter
for more information on filename conventions.
Enter "quit" to exit the ftp prompt.
7

25.7.2 FTP Session Example of Firmware File Upload

Figure 243 FTP Session Example of Firmware File Upload
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
More commands (found in GUI-based FTP clients) are listed earlier in this chapter.
Refer to Section on page 416
FTP over WAN.

25.7.3 TFTP File Upload

The device also supports the uploading of firmware files using TFTP (Trivial File
Transfer Protocol) over LAN. Although TFTP should work over WAN as well, it is
not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To transfer
the firmware and the configuration file, follow the procedure shown next.
Use telnet from your computer to connect to the device and log in. Because TFTP
1
does not have any security checks, the device records the IP address of the telnet
client and accepts TFTP requests only from this address.
P-2612HW-F1 User's Guide
to read about configurations that disallow TFTP and
Chapter 25 Tools
433