ZyXEL Communications P-2612HW-F1 User Manual page 221

After you hear the ring signal or the second party answers it, hang up the phone.
3
European Three-Way Conference
Use the following steps to make three-way conference calls.
When you are on the phone talking to someone, press the flash key to put the
1
caller on hold and get a dial tone.
Dial a phone number directly to make another call.
2
When the second call is answered, press the flash key and press "3" to create a
3
three-way conversation.
Hang up the phone to drop the connection.
4
If you want to separate the activated three-way conference into two individual
5
connections (one is on-line, the other is on hold), press the flash key and press
"2".
USA Type Supplementary Services
This section describes how to use supplementary phone services with the USA
Type Call Service Mode. Commands for supplementary services are listed in the
table below.
After pressing the flash key, if you do not issue the sub-command before the
default sub-command timeout (2 seconds) expires or issue an invalid sub-
command, the current operation will be aborted.
Table 63 USA Flash Key Commands
COMMAND SUB-
Flash
Flash
USA Call Hold
Call hold allows you to put a call (A) on hold by pressing the flash key.
If you have another call, press the flash key to switch back and forth between
caller A and B by putting either one on hold.
If you hang up the phone but a caller is still on hold, there will be a remind ring.
P-2612HW-F1 User's Guide
DESCRIPTION
COMMAND
Put a current call on hold to place a second call. After the
second call is successful, press the flash key again to
have a three-way conference call.
Put a current call on hold to answer an incoming call.
*98# Transfer the call to another phone.
Chapter 10 Voice
221