ZyXEL Communications P-2612HW-F1 User Manual page 266

Chapter 14 VPN
Table 77 Security > VPN > Setup > Edit
LABEL
IP Address Start
End / Subnet
Mask
Remote
Remote Address
Type
IP Address Start
End / Subnet
Mask
Address
Information
Local ID Type
266
DESCRIPTION
When the Local Address Type field is configured to Single, enter a
(static) IP address on the LAN behind your ZyXEL Device. When the
Local Address Type field is configured to Range, enter the beginning
(static) IP address, in a range of computers on your LAN behind your
ZyXEL Device. When the Local Address Type field is configured to
Subnet, this is a (static) IP address on the LAN behind your ZyXEL
Device.
When the Local Address Type field is configured to Single, this field
is N/A. When the Local Address Type field is configured to Range,
enter the end (static) IP address, in a range of computers on the LAN
behind your ZyXEL Device. When the Local Address Type field is
configured to Subnet, this is a subnet mask on the LAN behind your
ZyXEL Device.
Specify the IP addresses of the devices behind the remote IPSec router
that can use the VPN tunnel. The remote IP addresses must correspond
to the remote IPSec router's configured local IP addresses.
Two active SAs cannot have the local and remote IP address(es) both
the same. Two active SAs can have the same local or remote IP
address, but not both. You can configure multiple SAs between the
same local and remote IP addresses, as long as only one is active at
any time.
Use the drop-down menu to choose Single, Range, or Subnet. Select
Single with a single IP address. Select Range for a specific range of IP
addresses. Select Subnet to specify IP addresses on a network by
their subnet mask.
When the Remote Address Type field is configured to Single, enter a
(static) IP address on the network behind the remote IPSec router.
When the Remote Address Type field is configured to Range, enter
the beginning (static) IP address, in a range of computers on the
network behind the remote IPSec router. When the Remote Address
Type field is configured to Subnet, enter a (static) IP address on the
network behind the remote IPSec router.
When the Remote Address Type field is configured to Single, this
field is N/A. When the Remote Address Type field is configured to
Range, enter the end (static) IP address, in a range of computers on
the network behind the remote IPSec router. When the Remote
Address Type field is configured to Subnet, enter a subnet mask on
the network behind the remote IPSec router.
Select IP to identify this ZyXEL Device by its IP address.
Select DNS to identify this ZyXEL Device by a domain name.
Select E-mail to identify this ZyXEL Device by an e-mail address.
P-2612HW-F1 User's Guide