Configuring Static Route - ZyXEL Communications P-2612HW-F1 User Manual

Chapter 16 Static Route

16.2 Configuring Static Route

Click Advanced > Static Route to open the Static Route screen.
Figure 175 Advanced > Static Route
The following table describes the labels in this screen.
Table 102 Advanced > Static Route
LABEL
#
Active
Name
Destination
Netmask
Gateway
Modify
Apply
Cancel
324
DESCRIPTION
This is the number of an individual static route.
This field indicates whether the rule is active or not.
Clear the check box to disable the rule. Select the check box to enable it.
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number.
This parameter specifies the IP network subnet mask of the final
destination.
This is the IP address of the gateway. The gateway is a router or switch
on the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
Click the Edit icon to go to the screen where you can set up a static route
on the ZyXEL Device.
Click the Remove icon to remove a static route from the ZyXEL Device. A
window displays asking you to confirm that you want to delete the route.
Click this to apply your changes to the ZyXEL Device.
Click this to return to the previously saved configuration.
P-2612HW-F1 User's Guide