The Class Setup Screen - ZyXEL Communications P-2612HW-F1 User Manual

Table 107 Advanced > QoS > General
LABEL
Traffic
priority will
be
automatical
ly assigned
by
Apply
Cancel

18.3 The Class Setup Screen

Use this screen to add, edit or delete classifiers. A classifier groups traffic into data
flows according to specific criteria such as the source address, destination
address, source port number, destination port number or incoming interface. For
example, you can configure a classifier to select traffic from the same protocol
port (such as Telnet) to form a flow.
Click Advanced > QoS > Class Setup to open the following screen.
Figure 192 Advanced > QoS > Class Setup
P-2612HW-F1 User's Guide
DESCRIPTION
These fields are ignored if traffic matches a class you configured in the
Class Setup screen.
If you select ON and traffic does not match a class configured in the Class
Setup screen, the ZyXEL Device assigns priority to unmatched traffic based
on the IEEE 802.1p priority level, IP precedence and/or packet length. See
Section 18.5.4 on page 353
If you select OFF, traffic which does not match a class is mapped to queue
two.
Click Apply to save your settings back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
Chapter 18 Quality of Service (QoS)
for more information.
345