ZyXEL Communications P-2612HW-F1 User Manual page 263

The following table describes the fields in this screen.
Table 76 Security > VPN > Setup
LABEL
No.
Active
Name
Local Address
Remote
Address
Encap.
IPSec
Algorithm
Secure
Gateway IP
Modify
Apply
Cancel
P-2612HW-F1 User's Guide
DESCRIPTION
This is the VPN policy index number. Click a number to edit VPN policies.
This field displays whether the VPN policy is active or not. A Yes signifies
that this VPN policy is active. No signifies that this VPN policy is not
active.
This field displays the identification name for this VPN policy.
This is the IP address(es) of computer(s) on your local network behind
your ZyXEL Device.
The same (static) IP address is displayed twice when the Local Address
Type field in the VPN Setup - Edit screen is configured to Single.
The beginning and ending (static) IP addresses, in a range of computers
are displayed when the Local Address Type field in the VPN Setup -
Edit screen is configured to Range.
A (static) IP address and a subnet mask are displayed when the Local
Address Type field in the VPN Setup - Edit screen is configured to
Subnet.
This is the IP address(es) of computer(s) on the remote network behind
the remote IPSec router.
This field displays N/A when the Secure Gateway Address field
displays 0.0.0.0. In this case only the remote IPSec router can initiate
the VPN.
The same (static) IP address is displayed twice when the Remote
Address Type field in the VPN Setup - Edit screen is configured to
Single.
The beginning and ending (static) IP addresses, in a range of computers
are displayed when the Remote Address Type field in the VPN Setup -
Edit screen is configured to Range.
A (static) IP address and a subnet mask are displayed when the Remote
Address Type field in the VPN Setup - Edit screen is configured to
Subnet.
This field displays Tunnel or Transport mode (Tunnel is the default
selection).
This field displays the security protocols used for an SA.
Both AH and ESP increase ZyXEL Device processing requirements and
communications latency (delay).
This is the static WAN IP address or URL of the remote IPSec router. This
field displays 0.0.0.0 when you configure the Secure Gateway Address
field in the VPN-IKE screen to 0.0.0.0.
Click the Edit icon to go to the screen where you can edit the VPN
configuration.
Click the Remove icon to remove an existing VPN configuration.
Click this to save your changes and apply them to the ZyXEL Device.
Click this return your settings to their last saved values.
Chapter 14 VPN
263