Configuring The Wireless Client - ZyXEL Communications P-2612HW-F1 User Manual

Chapter 4 Tutorials
Click the WLAN Status hyperlink in the AP's Status screen. You can see if any
7
wireless client has connected to the AP.
Figure 12 AP: Status: WLAN Station Status

4.2.3 Configuring the Wireless Client

This section describes how to connect the wireless client to a network.
4.2.3.1 Connecting to a Wireless LAN
The following sections show you how to join a wireless network using the ZyXEL
utility, as in the following diagram. The wireless client is labeled C and the access
point is labeled AP.
There are three ways to connect the client to an access point.
• Configure nothing and leave the wireless client to automatically scan for and
connect to any available network that has no wireless security configured.
• Manually connect to a network.
• Configure a profile to have the wireless client automatically connect to a specific
network or peer computer.
This example illustrates how to manually connect your wireless client to an access
point (AP) which is configured for WPA-PSK security and connected to the
Internet. Before you connect to the access point, you must know its Service Set
IDentity (SSID) and WPA-PSK pre-shared key. In this example, the SSID is
"SSID_Example3" and the pre-shared key is "ThisismyWPA-PSKpre-sharedkey".
After you install the ZyXEL utility and then insert the wireless client, follow the
steps below to connect to a network using the Site Survey screen.
48
C
AP
P-2612HW-F1 User's Guide
Internet