Wireless Lan Advanced Setup - ZyXEL Communications P-2612HW-F1 User Manual

Chapter 8 Wireless LAN

8.2.5 Wireless LAN Advanced Setup

To configure advanced wireless settings, click the Advanced Setup button in the
AP screen. The screen appears as shown.
Figure 83 Network > Wireless LAN > AP > Advanced Setup
The following table describes the labels in this screen.
Table 29 Network > Wireless LAN > AP > Advanced Setup
LABEL
Wireless Advanced Setup
RTS/CTS
Threshold
Fragmentation
Threshold
Output Power
Level
Preamble
802.11 Mode
Back
Apply
Cancel
150
DESCRIPTION
Enter a value between 0 and 2432.
It is the maximum data fragment size that can be sent. Enter a value
between 256 and 2432.
Set the output power of the ZyXEL Device in this field. The higher the
number, the greater the output power. If there is a high density of APs in
the area, decrease the output power of the ZyXEL Device to reduce
interference with other APs. See the product specifications for more
information on your ZyXEL Device's output power.
Select a preamble type. Choices are Long, Short or Dynamic. The
default setting is Long. See the appendix for more information.
Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices
to associate with the ZyXEL Device.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices
to associate with the ZyXEL Device.
Select Mixed to allow either IEEE 802.11b or IEEE 802.11g compliant
WLAN devices to associate with the ZyXEL Device. The transmission rate
of your ZyXEL Device might be reduced.
Click this to return to the previous screen without saving changes.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to reload the previous configuration for this screen.
P-2612HW-F1 User's Guide