Port Forwarding Rule Edit - ZyXEL Communications P-2612HW-F1 User Manual

9.3.2 Port Forwarding Rule Edit

Use this screen to add or edit a port forwarding rule. Select User define in the
Service Name field of the Port Forwarding screen or click an existing rule's edit
icon in the Port Forwarding screen to display the screen shown next.
Figure 100 Network > NAT > Port Forwarding > Edit
The following table describes the fields in this screen.
Table 41 Network > NAT > Port Forwarding > Edit
LABEL
Active
Service Name Enter a name to identify this port-forwarding rule.
Start Port
End Port
Server IP
Address
Back
Apply
Cancel
P-2612HW-F1 User's Guide
DESCRIPTION
Click this check box to enable the rule.
Enter a port number in this field.
To forward only one port, enter the port number again in the End Port
field.
To forward a series of ports, enter the start port number here and the end
port number in the End Port field.
Enter a port number in this field.
To forward only one port, enter the port number again in the Start Port
field above and then enter it again in this field.
To forward a series of ports, enter the last port number in a series that
begins with the port number in the Start Port field above.
Enter the inside IP address of the server here.
Click Back to return to the previous screen.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
Chapter 9 NAT
177