Configuring Snmp - ZyXEL Communications P-2612HW-F1 User Manual

802.11g wireless adsl voip iad

Hide thumbs Also See for P-2612HW-F1:

Table of Contents

Chapter 20 Remote Management

Table 117 SNMP Traps

20.5.1 Configuring SNMP

To change your ZyXEL Device's SNMP settings, click Advanced > Remote MGMT

> SNMP. The screen appears as shown.

Figure 201 Advanced > Remote Management > SNMP

The following table describes the labels in this screen.

Table 118 Advanced > Remote Management > SNMP

Access Status

For intentional reboot:

For fatal error:

You may change the server port number for a service if needed,

however you must use the same port number in order to use that

service for remote management.

Select the interface(s) through which a computer may access the

ZyXEL Device using this service.

A trap is sent with the message "System reboot

by user!" if reboot is done intentionally, (for

example, download new files, CI command "sys

A trap is sent with the message of the fatal

code if the system reboots because of fatal

P-2612HW-F1 User's Guide