ZyXEL Communications P-2612HW-F1 User Manual page 418

Chapter 25 Tools
FTP and TFTP Firmware and Configuration File Uploads
These examples show you how to upload firmware and configuration files.
Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE your device.
FTP is the preferred method for uploading the firmware and configuration. To use
this feature, your computer must have an FTP client. The following sections give
examples of how to upload the firmware and the configuration files.
FTP File Upload Command from the DOS Prompt Example
Launch the FTP client on your computer.
1
Enter "open", followed by a space and the IP address of your device.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "1234").
4
Enter "bin" to set transfer mode to binary.
5
Use "put" to transfer files from the computer to the device, for example, "put
6
firmware.bin ras" transfers the firmware on your computer (firmware.bin) to the
device and renames it "ras". Similarly, "put config.rom rom-0" transfers the
configuration file on your computer (config.rom) to the device and renames it
"rom-0". Likewise "get rom-0 config.rom" transfers the configuration file on the
device to your computer and renames it "config.rom." See earlier in this chapter
for more information on filename conventions.
Enter "quit" to exit the ftp prompt.
7
FTP Session Example of Firmware File Upload
Figure 228 FTP Session Example of Firmware File Upload
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
418
P-2612HW-F1 User's Guide