The Reset Button; The Wlan Button - ZyXEL Communications P-2612HW-F1 User Manual

Chapter 1 Introduction

1.5 The RESET Button

If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the passwords will be reset to the defaults.
Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for
2
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.

1.6 The WLAN Button

Use the WLAN button on the top of the device to turn the wireless LAN off or on.
Make sure the POWER LED is on (not blinking) before using the WLAN button.
• Press the WLAN button for one second and release it. The WLAN LED should
change from on to off or vice versa.
• Press the WLAN button for five seconds to turn on WPS. See
page 163
30
for more on using WPS to configure your wireless clients.
Section 8.9.5.1 on
P-2612HW-F1 User's Guide