ZyXEL Communications P-2612HW-F1 User Manual page 452

Chapter 28 Product Specifications
Table 161 Voice Features
Call Park and
Pickup
Call Return
Country Code
Do not Disturb
(DnD)
Auto Dial
Phone config
HTTP pincode
Firmware update
enable / disable
Call waiting
452
Call park and pickup lets you put a call on hold (park) and then
continue the call (pickup). The caller must still pay while the call is
parked.
When you park the call, you enter a number of your choice (up to
eight digits), which you must enter again when you pick up the call. If
you do not enter the correct number, you cannot pickup the call. This
means that only someone who knows the number you have chosen
can pick up the call.
You can have more than one call on hold at the same time, but you
must give each call a different number.
With call return, you can place a call to the last number that called
you (either answered or missed). The last incoming call can be
through either SIP or PSTN.
Phone standards and settings differ from one country to another, so
the settings on your ZyXEL Device must be configured to match those
of the country you are in. The country code feature allows you to do
this by selecting the country from a list rather than changing each
setting manually. Configure the country code feature when you move
the ZyXEL Device from one country to another.
This feature allows you to set your phone not to ring when someone
calls you. You can set each phone independently using its keypad, or
configure global settings for all phones using the command line
interpreter.
You can set the ZyXEL Device to automatically dial a specified
number immediately whenever you lift a phone off the hook. Use the
Web Configurator to set the specified number. Use the command line
interpreter to have the ZyXEL Device wait a specified length of time
before dialing the number.
The phone config table allows you to customize the phone keypad
combinations you use to access certain features on the ZyXEL Device,
such as call waiting, call return, and call forward. The phone config
table is configurable in command interpreter mode.
If your service provider uses an auto provisioning server, you need to
enter a personal identification number (supplied by your service
provider) before you first use the feature.
If your service provider uses this feature, you hear a recorded
message when you pick up the phone when new firmware is available
for your ZyXEL Device. Enter *99# in your phone's keypad to have
the ZyXEL Device upgrade the firmware, or enter #99# to not
upgrade. If your service provider gave you different numbers to use,
enter them instead. If you enter the code to not upgrade, you can
make a call as normal. You will hear the recording again each time
you pick up the phone, until you upgrade.
This feature allows you to hear an alert when you are already using
the phone and another person calls you. You can then either reject
the new incoming call, put your current call on hold and receive the
new incoming call, or end the current call and receive the new
incoming call.
P-2612HW-F1 User's Guide