ZyXEL Communications P-2612HW-F1 User Manual page 105

Table 14 Network > WAN > Internet Access Setup (continued)
LABEL
Encapsulation
User Name
Password
Service Name
VLAN ID
Vlan Tagging
IP Address
IP Address
DNS Server
First, Second,
and Third DNS
Server
Connection
Nailed-Up
Connection
Connect on
Demand
P-2612HW-F1 User's Guide
DESCRIPTION
Select the method of encapsulation used by your ISP from the drop-
down list box.
(PPPoE encapsulation only.)
Enter the user name exactly as your ISP assigned. If assigned a name
in the form user@domain where domain identifies a service name,
then enter both components exactly as given.
(PPPoE encapsulation only.)
Enter the password associated with the user name above.
(PPPoE encapsulation only.)
Type the name of your PPPoE service here.
Enter the VLAN ID for this connection
Select this to enable VLAN tagging.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP
address is not fixed; the ISP assigns you a different one each time you
connect to the Internet.
Select Obtain an IP Address Automatically if you have a dynamic
IP address; otherwise select Static IP Address and type your ISP
assigned IP address in the IP Address field below.
Select Obtained From ISP if your ISP dynamically assigns DNS
server information (and the ZyXEL Device's WAN IP address) and you
select Obtain an IP Address Automatically.
Select UserDefined if you have the IP address of a DNS server. Enter
the DNS server's IP address in the field to the right. If you chose
UserDefined, but leave the IP address set to 0.0.0.0, UserDefined
changes to None after you click Apply. If you set a second choice to
User-Defined, and enter the same IP address, the second
UserDefined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. You must
have another DNS server on your LAN, or else the computers must
have their DNS server addresses manually configured. If you do not
configure a DNS server, you must know the IP address of a computer
in order to access it.
(PPPoE encapsulation only.)
(PPPoE encapsulation only.)
Select this option when you want your connection up all the time. The
ZyXEL Device will try to bring up the connection automatically if it is
disconnected.
(PPPoE encapsulation only.)
Select this option when you don't want the connection up all the time
and specify an idle time-out in the Max Idle Timeout field.
Chapter 6 WAN Setup
105