The Www Screen - ZyXEL Communications P-2612HW-F1 User Manual

Remote Management and NAT
When NAT is enabled:
• Use the ZyXEL Device's WAN IP address when configuring from the WAN.
• Use the ZyXEL Device's LAN IP address when configuring from the LAN.
System Timeout
There is a default system management idle timeout of five minutes (three
hundred seconds). The ZyXEL Device automatically logs you out if the
management session remains idle for longer than this timeout period. The
management session does not time out when a statistics screen is polling.

20.2 The WWW Screen

To change your ZyXEL Device's World Wide Web settings, click Advanced >
Remote MGMT to display the WWW screen.
Figure 197 Advanced > Remote Management > WWW
The following table describes the labels in this screen.
Table 114 Advanced > Remote Management > WWW
LABEL
Port
Access Status
P-2612HW-F1 User's Guide
DESCRIPTION
You may change the server port number for a service if needed,
however you must use the same port number in order to use that
service for remote management.
Select the interface(s) through which a computer may access the ZyXEL
Device using this service.
Chapter 20 Remote Management
361