ZyXEL Communications P-2612HW-F1 User Manual page 216

Chapter 10 Voice
Pulse dialing sends a series of clicks to the local phone office in order to dial
numbers.
MWI (Message Waiting Indication)
Enable Message Waiting Indication (MWI) enables your phone to give you a
message–waiting (beeping) dial tone when you have a voice message(s). Your
VoIP service provider must have a messaging system that sends message waiting
status SIP packets as defined in RFC 3842.
Custom Tones (IVR)
IVR (Interactive Voice Response) is a feature that allows you to use your
telephone to interact with the ZyXEL Device. The ZyXEL Device allows you to
record custom tones for the Caller Ringing Tone and On Hold Tone functions.
The same recordings apply to both the caller ringing and on hold tones.
Table 61 Custom Tones Details
LABEL
Total Time for All Tones
Time per Individual Tone
Total Number of Tones
Recordable
Recording Custom Tones
Use the following steps if you would like to create new tones or change your
tones:
Pick up the phone and press "****" on your phone's keypad and wait for the
1
message that says you are in the configuration menu.
Press a number from 1101~1108 on your phone followed by the "#" key.
2
Play your desired music or voice recording into the receiver's mouthpiece. Press
3
the "#" key.
You can continue to add, listen to, or delete tones, or you can hang up the
4
receiver when you are done.
Listening to Custom Tones
Do the following to listen to a custom tone:
3. The ZyXEL Device does not support pulse dialing at the time of writing.
216
3
DESCRIPTION
128 seconds for all custom tones combined
20 seconds
8
You can record up to 8 different custom tones but the total
time must be 128 seconds or less.
P-2612HW-F1 User's Guide