Specifying the
Physical Location of
the Stack
Accessing the
Getting Started
Pages
You can specify the physical location of the stack using the Location
page.
To access the page:
1 Click the Management Settings icon on the side-bar.
2 Click the Location hotlink. The Location page is displayed as shown in
Figure 4-13.
The Location page
Figure 4-13
The Getting Started pages allow you to enter basic setup information
for the stack.
To access the Getting Started pages:
1 Click the Management Settings icon on the side-bar.
2 Click the Getting Started hotlink. The first Getting Started page,
Getting Started - Introduction, is displayed.
For information about using the Getting Started pages, see "About The
Getting Started Pages" on page 4-4.
Changing the Management Settings for the Stack
4-23