Displaying And Maintaining Voice Vlan; Voice Vlan Configuration Example; Voice Vlan Configuration Example (Automatic Mode) - 3Com WX3000 Series Operation Manual

Displaying and Maintaining Voice VLAN

Display the information about ports on
which voice VLAN configuration fails
Display the voice VLAN configuration
status
Display the currently valid OUI addresses
Display the ports operating in the current
voice VLAN

Voice VLAN Configuration Example

Voice VLAN Configuration Example (Automatic Mode)

Network requirements
Create a voice VLAN and configure it to operate in automatic mode to enable the port to which an IP
phone is connected to join or exit the voice VLAN automatically and voice traffic to be transmitted within
the voice VLAN, as shown in
Create VLAN 2 and configure it as a voice VLAN, with the aging time being 100 minutes.
The IP phone sends tagged packets. It is connected to GigabitEthernet 1/0/1, a hybrid port, with
VLAN 6 being its default VLAN. Set this port to operate in automatic mode.
You need to add a user-defined OUI address 0011-2200-000, with the mask being ffff-ff00-0000
and the description string being "test".
Figure 1-2 Network diagram for voice VLAN configuration (automatic mode)
Device A
VLAN 2
GEth1/0/1
VLAN 2
010- 1001
OUI: 0011- 2200- 0000
Mask:ffff-ff00- 0000
Configuration procedure
# Create VLAN 2 and VLAN 6.
<DeviceA> system-view
[DeviceA] vlan 2
[DeviceA-vlan2] quit
[DeviceA] vlan 6
[DeviceA-vlan6] quit
# Set the aging time for the voice VLAN.
To do...
Figure 1-2.
Internet
Use the command...
display voice vlan error-info
display voice vlan status
display voice vlan oui
display vlan vlan-id
Device B
1-9
Remarks
You can execute the
display command in
any view.