10-18
LCR Routing for Toll Information
Technical Manuals Online! - http://www.tech-man.com
Example
If a call is placed at 5:45 pm on a Monday, then according to the Daily
Start Time Table (using default values) the entry for time period two of
the weekly schedule is checked. Because it is Monday the entry for time
period two on Monday is used and the result is that the Time Period
Route List number two (again using default values) is used for all routes.
Thus, the call is routed according to the entries in Time Period Two Route
List no matter what route (00–15) is selected.
Figure 10-3: Daily and Weekly Start Time Table
Programming Steps
1. Press the TOLL INFO flexible button (FLASH 75, Button #8) . The
following message displays:
LCR R OU TE FOR 55 5 - 1 21 2
EN TE R R OU TE
2. Enter a valid Route List number (00–15) for the Route to be
referenced in the Route List table.
3. Press the HOLD button after programming the Route number. A
confirmation tone is heard and the display updates.
4. Enable LCR at this point.
LCR Operation