Co / Pbx Programming; Universal Night Answer (Una) - Vodavi Starplus Triad-S System Programming Manual

Page A Introduction

CO / PBX Programming

Universal Night Answer (UNA)

Technical Manuals Online! - http://www.tech-man.com
Programming Steps
1. Press the CO/PBX flexible button (FLASH 40, Page A, Button #2).
2. Enter a 0 or 1 which corresponds with the following entries:
[0] = PBX
[1] = CO
P BX / CO
CO
3. Press HOLD to save the entry. A confirmation tone is heard.
Description
Each individual outside line connected to the system may be
programmed as a CO or PBX line. Use the PBX mark when identifying
Centrex lines. By default, all lines are assigned as CO lines.
Programming Steps
1. Press the UNA flexible button (FLASH 40, Page A, Button #3).
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
[0] = Disabled
[1] = Enabled
U NA
EN AB LE D
3. Press HOLD to save the entry. A confirmation tone is heard.
Description
If a line is marked UNA, this activates night service answering of incoming
calls on this line by stations not normally assigned access to the line(s).
This station must have a direct CO appearance or an available loop key
assigned to do this. Lines marked as UNA also activate Night Ringing over
External Page when in the night mode if External Night Ringing is set to
Yes. By default, UNA is enabled.
0- 1
0- 1
3-5