Vodavi Starplus Triad-S System Programming Manual page 166

Direct Inward Dialing (DID) Programming
NUMBER
Technical Manuals Online! - http://www.tech-man.com
Description
DID calls are treated as an incoming call and follow the same rules
established for CO lines. DID information transferred from the network is
captured and translated to direct a specific DID number to a specific
station, ACD or Hunt group of stations, or Voice Mail group. The DID call
appears at the destination station under an assigned LOOP or CO button.
When receiving a DID call, the destination station hears the CO line
ringing and the assigned CO or LOOP button flashes at the incoming CO
line flash rate. The destination station then presses the flashing CO or
LOOP button, is connected to the incoming DID call, and CO line ringing
stops and the LED for the CO or LOOP button lights steady.
If the outside caller disconnects from a two-party conversation, the
Central Office opens the loop and returns the line to idle state. The
system detects the disconnect signal, release the line, and provides a
busy tone to the keyset/SLT (unless the SLT is a VM port), and disconnects
from the DID line. If the extension called hangs up the phone, the central
office detects disconnects, and returns the line to the idle state.
The buttons on the digital telephone are defined as shown when
entering the DID Table programming area:
ROU TE PHONE
NUMBER
1 Q
BACK
SPACE
5 T
9 O
13 D
17 J
21 Z
By default, all entries in the DID Table (000-999) have phone numbers
assigned. Refer to
NAME
2 W
6 Y
10 P
14 F
U P DOWN
18 K
22 X
Figure 3-9 for additional information.
CLEAR
ENTRY
3 E
7 U
1 1 A 12
15 G 16
19 L
23 C 24
3-35
4 R
8 I
S
H
20 ;
V