Figure 4-13: Create A Managed Remote Subnet Page - ADTRAN BlueSecure Controller Setup And Administration Manual

Chapter 4: Networks
Select Managed-side Remote Subnet from the Create drop-down list on the Network
2.
page. The Create a Managed Remote Subnet page appears as shown in Figure 4-
13.
The Enable checkbox is marked by default to make the managed remote subnet
3.
available to wireless clients. Clearing the checkbox makes the managed remote
subnet unavailable.
Complete the following options below.
4.
•
•
•
4-20

Figure 4-13: Create a Managed Remote Subnet Page

Name - Enter a unique name for the managed remote subnet, e.g.,
SatelliteOffice1 or RemoteOffice1, etc.
Gateway IP address for BSC to reach remote subnet - Enter the IP address of the
router on the managed side of the network to which the BSC will send traffic
destined for the managed remote subnet. The router address is required because
the managed remote subnet is not connected to the BSC directly.
Default gateway IP address for remote clients to reach the BSC - When handing
out addresses to wireless clients via DHCP, the BSC must include the default
gateway IP address that wireless clients will use to reach the BSC. This is the IP
address of the local router at the managed remote subnet.