Table of Contents
Advertisement
Creating Network Services and Services Groups
Figure 8-14: Create a Service Page
Name
Enter a meaningful name for the network service.
Service Settings
Define the service settings as appropriate for your network.
Protocol - Specify whether the network service supports TCP, UDP, both TCP/UDP, ICMP,
or some Other protocol.
Port - Enter the port number(s) used by TCP, UDP, or both TCP/UDP protocols. Use a
hyphen to designate a port range and use a comma between each port or port range
entry. For example, to specify ports 1024 through 2000 and also port 2003, enter
1024-2000,2003.
Protocol Number - If you have specified Other for the network service protocol, the Port
field changes to Protocol Number. Enter the appropriate protocol number.
For example, if you wanted to create a service for IPSec encrypted data using ESP
(encapsulated security payload), you would enter protocol number 50.
Quality of
Optional. Define the QoS, i.e., traffic priority level and DSCP marking for the service.
Service
Enable QoS for this Service - Mark this checkbox to apply Priority and DSCP settings to
this network service. Clear this checkbox to enable the priority and DSCP marking
settings defined in the user role to take precedence over any such settings defined for the
network service.
8-15
BlueSecure™ Controller Setup and Administration Guide
Advertisement
Table of Contents
