Table of Contents
Advertisement
Chapter 11: Web Logins
•
On the BSC side, set "Server Address" to test.authorize.net and check off (turn on)
"Enable test mode"
•
On the Authorize.net Merchant Interface, switch account to test mode by going to
Account Settings --> Test Mode
CyberSource
To setup a hotspot account to be billed through CyberSource, a merchant id and a private
key is required on the Edit Hotspot Account Generation for custom login page. The
private key must be downloaded from the CyberSource Business Center:
Go to https://ebc.cybersource.com/ebc/login/Login.do
1.
Log in by entering the account credentials.
2.
3.
Once logged in, click on Account Management in the menu on the left.
Click Transaction Security Keys in the submenu. A new page will be loaded with the
4.
title of Transaction Security Keys.
Click on the button labelled Generate Key and follow the instructions.
5.
When the key is successfully uploaded to a BSC, the Hotspot Account Generation
6.
page will contain the following message in the Key Upload section.
Key exists, serial number is
153333333333333333
The serial number should be the same as the one in the CyberSource Business Center.
Micros-Fidelio
To setup a hotspot account to be billed through Micros-Fidelio PMS, the Opera 4
PMS
server must be licensed to work with Bluesocket products. Contact your Micros-
Fidelio sales representative to purchase a license.
Enabling Users to Create Hotspot Accounts
In order for end-users to be able to create an account they can use to access the Internet
using a hotspot account, you need to enable and configure the hotspot account
generation feature.
Note: If Hotspot Account Generation is used in an environment that has BSC Replication
enabled, the feature should only be enabled on the Replication Master. Hotspot Account
Generation on a Replication Node will be denied.
11-14
Figure 11-8: Hotspot Account Generation Page
Advertisement
Table of Contents
