Defining The Bsc Protected Physical Interface; Figure 4-1: Edit Protected Interface (Eth0) Page - ADTRAN BlueSecure Controller Setup And Administration Manual

Chapter 4: Networks

Defining the BSC Protected Physical Interface

You must configure the BSC to communicate with the protected (i.e., wired) side of your
network. The protected side of your network includes your enterprise servers and
resources.
Specify the following sections as required and click Save to store the information to the
BSC database. You may be prompted to restart the BSC. We recommend that you do not
restart the BSC until you have completely finished configuring the BSC for use in your
network.Any parameter changes you have made are displayed in the Current Status
panel after you click the link to restart the BSC.
Displaying the Click the Network tab in the BSC administrator console, and then click the Protected tab.
"Edit Protected
The Edit Protected interface (eth0) page appears as shown in Figure 4-1.
interface (eth0)"
page
The current settings for the BSC protected interface are listed in the Current status panel of
the page. Click Fill Up to enter the current live data for IP/Netmask/Gateway/DNS into
the form. This is particularly useful when converting from DHCP-assigned to static
addresses.
4-2

Figure 4-1: Edit Protected Interface (eth0) Page