Figure 4-3: Create A Protected Vlan Page - ADTRAN BlueSecure Controller Setup And Administration Manual

Chapter 4: Networks
VLAN Settings Ensure you have set up the protected physical interface as described in "Defining the
1.
BSC Protected Physical Interface" on page 4-2.
The Enable checkbox is marked by default to make the protected VLAN available.
2.
Enter the protected VLAN settings, as described below:
3.
•
•
•
Interface Ensure you have set up the protected physical interface as described in "Defining the
1.
Settings BSC Protected Physical Interface" on page 4-2.
The remaining protected-side VLAN parameter settings are common to the protected
2.
physical interface. Configure these parameters as described in "Defining the BSC
Protected Physical Interface" on page 4-2. You must enable multicast on the Protected
Interface if you have one or more protected VLANs that use multicast.
4-6
Name - A unique name for the protected-side VLAN.
VLAN ID - The VLAN identification number. The specified ID must be unique on
the protected side of the network and in the range of 2 to 4094. The protected-
side VLAN ID you create here might match a managed-side VLAN ID to create a
pass-through VLAN as described in Appendix A, "An Overview of Virtual LANs."
VLAN Type - The type of VLAN to create. Currently the IEEE 802.1q VLAN
standard is the only VLAN type supported.

Figure 4-3: Create a Protected VLAN Page