Table of Contents
Advertisement
Chapter 15: Status
Displaying BSC Secure Mobility
If you have configured the BSC Secure Mobility feature to enable users to roam across
subnets seamlessly (See "Step 1: Designate and Set Up the Mobility Node List Master" on
page 14-6 for setup details), you can display status information about a users' roaming
status.
To display BSC Secure Mobility status information:
Click the Status tab in the BSC administrator console, click the Summary tab, and then
click the Secure Mobility link at the top of the page.
The BSC Secure Mobility summary page displays the following information about use of
the BSC Secure Mobility feature on your network:
•
Status - Secure Mobility status of BSC. Possible values are:
-
-
-
-
-
-
•
StartIP - Protected interface IP address of BSC to which you are connected.
•
EndIP - Protected interface IP address of remote BSC with which this BSC is
attempting to establish a communication tunnel.
•
StartTunnelIP - IP address of BSC on which communications tunnel was initiated.The IP
address will be unique to the Secure Mobility MatriX in which this BSC has
membership.
•
EndTunnelIP - IP address of remote BSC on which communications tunnel was
terminated.
•
RX Packets - Count of "heartbeat" packets received at this BSC. The BSC exchanges
pings with its remote Secure Mobility partner.
•
TX Packets - Count of "heartbeat" packets transmitted to remote Secure Mobility
partner BSC.
•
RX RPCs - Count of Remote Procedure Calls received at this BSC from its remote
Secure Mobility partner BSC.
•
TX RPCs - Count of Remote Procedure Calls transmitted to remote Secure Mobility
partner BSC.
Displaying Load Sharing Status
You can also display a quick visual snapshot of your configured Load Sharing Group by
clicking Status/Summary, and then clicking the Loadsharing link at the top of the page.
The status summary for a three-node Load Sharing Group that is up and fully operational
would look similar to the following figure.
15-12
®
INIT - BSC is initializing its Secure Mobility setup with a remote BSC.
SETUP - BSC is setting up a Secure Mobility communication tunnel with a remote
BSC.
TUNNELUP - BSC has established a Secure Mobility communication tunnel to a
remote BSC.
TUNNELFIN - Communication tunnel setup to remote Secure Mobility partner has
been completed.
OPERATIONAL - BSC's Secure Mobility setup is operational.
FAILED - BSC's Secure Mobility communications with a remote BSC have failed.
Status
Advertisement
Table of Contents
