Table of Contents
Advertisement
Choose a level, stable desktop that will support the weight of the BSC.
1.
Install one of the four supplied self-adhesive rubber feet in each corner on the bottom
2.
of the BSC chassis.
Install the rubber feet to prevent the BSC chassis from slipping on the desktop.
After mounting the BSC chassis on the desktop, connect the BSC to your network as
described in "Connecting the BlueSecure Controller to Your Network" on page 2-13, and
then power up the BSC by following the procedure given in "Connecting the BSC to its
Power Source" on page 2-13.
BSC-2100 and BSC-2200/3200/5200 Desktop Mounting
To mount the Bluesocket BSC-2100 or the BSC-2200/3200/5200 Controllers on a
desktop:
Choose a level, stable desktop that will support the weight of the BSC.
1.
2.
Install a rubber pad on each of the four desktop bumpers as shown in Figure 2-5.
Install each of the BSC's four desktop bumpers as shown in Figure 2-6.
3.
Snap the bumpers into the BSC chassis to prevent the chassis from slipping on the
desktop and to enhance its appearance.
Install the BSC chassis cap as shown in Figure 2-7.
4.
The cap enhances the appearance of the BSC chassis while resting on the desktop.
After mounting the BSC chassis on the desktop, connect the BSC to your network as
described in "Connecting the BlueSecure Controller to Your Network" on page 2-13, and
then power up the BSC by following the procedure given in "Connecting the BSC to its
Power Source" on page 2-13.
BlueSecure™ Controller Setup and Administration Guide
Figure 2-5: Attaching a Rubber Pad to a BSC-2100/5200 Bumper
Figure 2-6: Attaching the BSC-2100/5200 Chassis Desktop Bumper
Mounting the BlueSecure Controller Chassis
2-11
Advertisement
Table of Contents
