Secure Mobility® Matrix - ADTRAN BlueSecure Controller Setup And Administration Manual

14
BlueSecure™ Controller Setup and Administration Guide
This chapter provides procedures for configuring a large-scale wireless network
that requires two or more BlueSecure Controllers. The term Security Mobility
MatriX refers to three functional areas: Secure Mobility, Replication, and Load
Sharing.
This chapter is organized as follows:
• An Overview of the Secure Mobility MatriX
- Reasons for Deploying a Secure Mobility MatriX
- General Configuration Procedure
• Secure Mobility®
- How Secure Mobility Works
- Network Requirements
- Step 1: Designate and Set Up the Mobility Node List Master
- Step 2: Create a List of Nodes
- Step 3: Set Up Secure Mobility® on the Nodes
- Step 4: Restart Services on the Mobility Master and All Nodes
- Tracking Secure Mobility Status
- Enabling VLAN Roaming Across LSG BSCs
• Replication
- A Comparison of Standard and Cascaded Replication
- Step 1: Set Up Replication on the Master
- Step 2: Create a List of Replication Nodes on Master
- Step 3: Set Up Replication on the Nodes
- Step 4: Set Up Cascaded Replication (More than Ten BSCs)
- Configuring a Replication Override
- Tracking Replication Status
• Load Sharing
- Typical Configuration
- Network Requirements
- Configuring BSC Load Sharing (Single Subnet, NAT Enabled)
- Configuring BSC Load Sharing (No NAT)
- Verifying Your Load Sharing Configuration
Secure Mobility
®
MatriX
14-1