Table of Contents
Advertisement
Purge DHCP
Mark this checkbox to purge existing IP addresses leased by the DHCP server. Enabling
leases
this option means that clients might receive different IP addresses when issued by the
DHCP server.
Netstat
List statistics about the network including socket status, interfaces that have been auto-
configured, memory statistics, etc. The Genmask column refers to the Netmask. The
heading uses the following codes: Proto (TCP, UDP, or ICMP), Recv-Q, Send-Q (packet
counters) Local_Address (IP and Port), Foreign_Address (IP and Port), and State.
ARP
Displays the BSC's address resolution protocol (ARP) table.The ARP table lists the
mapping of Layer 2 physical addresses to Layer 3 IP addresses for all of the hosts that the
computer has learned about through ARP.
Show Processes
List the status (IS running/NOT running/IS disabled) of all BSC processes. A process that
is not running has likely failed and should be restarted under Maintenance Restart
Services. A process that is disabled can be enabled through the GUI configuration.
Show Cisco
Displays information about Cisco devices connected directly to the BSC. You must have
CDP Neighbors
configured Cisco Discovery Protocol (CDP) passthrough and enabled the CDP "show"
feature on the BSC, as described in "Cisco Discovery Protocol Passthrough" on page 10-
25 before executing this test.
High TCP
Show IP Addresses with more than 50 connections. A mechanism to find heavy usage
Connection
applications that might put a strain on the controller, such as point-to-point applications
Counts
that can use hundreds, and in some cases thousands, of TCP connections.
Show Network
Show the output of ifconfig, useful when remote console access is not available, for
Interface
example for a remote site.
Parameters
Show BSAP
Shows a summary of AP channels, grouped by unique BG and A channel.
Channel
Summary
Show BSAP
Shows a summary of AP power, grouped by unique BG and A power.
Power Summary
Show BSAP
Shows a group count of each AP hardware and firmware version.
Hardware
Summary
Callhome to
Mark this radio button to specify a Port number for Callhome connection to the support
Bluesocket
server. The result is that an ssh port is opened back to the support IP address. Only one
user can log onto the support servers through this tunnel at any one time. Contact your
Support Representative for details prior to connecting.
Under normal circumstances, there is no tunnel to the support server and the status text on
the Diagnostics page will report the Call Home Status Connectivity as "Not Connected,"
and the Task Execution Menu page will display with the radio button "Callhome to
Bluesocket". Upon a successful connection, the status text on the Diagnostics page reports
the Call Home Status Connectivity as "Connected on <port>", and the radio button on the
Task Menu changes from "Callhome to Bluesocket" to "Disconnect".
Executing the
Click Process to execute the selected test.
test
Test results are displayed on the right side of the screen.
Note: It may take several minutes for results from the traceroute test to appear, especially
if devices cannot be reached.
BlueSecure™ Controller Setup and Administration Guide
Performing Standard Network Diagnostic Tests
15-19
Advertisement
Table of Contents
