Table of Contents
Advertisement
Select the Sensor Frequency Band in which to scan (BSAP-1800s with external
3.
antennas only). This determines which bands the BSAP will sense when it is scanning.
It takes less time to scan all the channels when you limit the BSAP to a single band.
Channel
The Auto Channel Select checkbox only provides an auto mode on the global tab since
Options
selecting channel on a global basis is not recommended.
When multiple BSAPs are deployed in the same area, set the channel on neighboring
BSAPs at least five channels apart to avoid interference with each other. For example, in
the United States you can deploy up to three BSAPs in the same area (e.g., channels 1, 6,
11).
Maximum
Adjust the power of the radio signals transmitted from the BSAP by selecting a
Transmit Power
transmission power level from the drop-down menu.
The higher the transmission power, the farther the transmission range. Power selection is
not just a trade off between coverage area and maximum supported clients. You also
have to ensure that high-power signals do not interfere with the operation of other radio
devices in the service area. (Default: 100% transmission power for the selected country/
region)
You can also adjust the transmission power level settings using the (+) and (-) buttons to
the right of the drop-down menu.
BlueSecure™ Controller Setup and Administration Guide
Configuring Global Radio Settings
12-11
Advertisement
Table of Contents
