Table of Contents
Advertisement
Displaying Power over Ethernet (PoE) Status
For the BSC 600/1200, you can display the PoE status, as shown in
The status summary for a three-node Load Sharing Group that is up and fully operational
would look similar to the following figure.
There are two lines in the PoE Summary page, PoE State and PoE Activity. These two lines
match the LED rows on the front of the BSC, PoE Enabled, and PoE Activity.
•
PoE Enabled shows one of two states, Disabled or Enabled. (The state is based on the
PoE configuration specified on each port on the Edit Managed interface page; for
information on software enabling PoE on the Edit Managed interface page, see "Port
settings" on page 4-12).
•
PoE Activity indicates one of the three states as seen via the PoE Activity LED's:
"Power" if AP is connected and powered, "Searching" if port is set active and
searching for an AP to power, and "Disabled" if port is disabled.
Generating and Displaying BSC Reports
You can generate either pre-defined or customized reports summarizing your wireless
network's performance and activity. The information about reports is organized as
follows:
•
"Using Pre-defined Report Definitions" on page 15-14.
•
"Creating a Custom Report Definition" on page 15-14.
•
"Creating a BSC Report" on page 15-15.
•
"Displaying or Delivering a Report" on page 15-16.
BlueSecure™ Controller Setup and Administration Guide
Figure 15-10: Load Sharing Status Summary
Figure 15-11: Power over Ethernet (PoE) Status Summary
Displaying Power over Ethernet (PoE) Status
15-13
Advertisement
Table of Contents
