Listing Of Accessible Functions; Access Procedure - ADTRAN BlueSecure Controller Setup And Administration Manual

Software release version: 6.5
Table of Contents

Advertisement

Appendix D:

Listing of Accessible Functions

1) dbinit - Restore all values in the BSC back to their defaults.
2) ifconfig - Show the NIC settings for the protected, managed, or failover interface.
3) processes - Show a list of all running processes.
4) restart - Restart the BSC software.
5) switch - Switch to the alternate runtime software image. You must subsequently
issue the reboot command for the switch to take effect.
6) reboot - Reboot the BSC machine.
7) specials - [Reserved for Bluesocket use only].
8) clean - Delete older event logs. This is useful when disk usage is high.
9) exit - Exit the serial port session.
a) admin password recovery: Set the default admin account to its default password.
i) interface: Set the BSC's protected interface address.
Type i followed by IP, Netmask, then gateway for fixed ip. For example:
i 192.168.100.30 255.255.252.0 192.168.100.1
Type i followed by the word 'dhcp' for dhcp. For example:
i dhcp
Warning: If you make a mistake and need to erase what you've typed, most serial
programs do not take backspace characters. Instead use CTRL-U to erase the entire line
and then reenter the entire line.

Access Procedure

Note: Before beginning the procedure listed below, verify that the option to access the
BSC via its serial port is enabled in the BSC administrator console as described in
"Miscellaneous BSC Options" on page 10-24.
To access the BSC serial port functions:
1.
Connect a nine-pin null-modem serial cable between the nine-pin serial port on the
back of the BSC and your laptop computer.
Run a terminal emulation program on your laptop computer configured with the
2.
following settings:
Initiate the connection to the BSC.
3.
Enter the following password at the displayed password prompt:
4.
wg1000s
A menu appears listing the commands described above.
Enter a command number/letter at the prompt, or exit the serial port session.
5.
D-2
Port - COM1
bps - 9600
Data bits - 8
Stop bits - 1
Parity - None
Flow control - None

Advertisement

Table of Contents
loading

Table of Contents