BlueProtect
The license is supplied by Bluesocket as part of your BlueSecure Controller distribution if
you have purchased the endpoint scanning option.
Note: A unique BlueProtect license is required for all Controllers even if in a load sharing
or mobility mesh.
To enter your Bluesocket BlueProtect unlock license:
Click the Maintenance tab, and then click the Licenses tab.
1.
In the BlueProtect EndPoint Scanning section, enter your License.
2.
Click Save Licenses to save the license information to the BSC database.The page
3.
updates to display the link "click here to proceed to enable and configure endpoint
scanning".
Click the link to display the General HTTP Settings page. Continue the configuration of
BlueProtect as explained in "Configuring Landing Page Text" on page C-4
BSC
Each BSC has a hard limit to the number of logged in users. This is determined based on
the hardware model. For example the BSC-600 supports 64 logged in users. When the
BSC counts users, it counts the number of logged in users (not the number of total users).
Note also that Bluesocket Access Points, which are on the managed side and logged into
the "Access Point Services" role, are not counted. So a BSC-600 could have 64 users
and 8 Bluesocket Access Points.
To install licenses for BSC software subsystems:
Click the Maintenance tab and then click Licenses.
1.
On the BSC Manage Licenses page, enter the BSC User License and then click Reset
2.
BlueSecure™ Controller Setup and Administration Guide
Figure 16-12: Manage Licenses page
Licenses
16-13